Network Setting 27
6 Network Setting
This chapter introduces how to configure IP address, FTP, SIP server, DDNS, and UPnP.
Basic 6.1
6.1.1 TCP/IP
You can modify the IP address and port number of the VTO.
Select Network Setting > Basic. Step 1
The TCP/IP information and port information are displayed. See Figure 6-1.
TCP/IP and port Figure 6-1
Enter the network parameters and port number you planed, and then click Save. Step 2
The VTO will reboot, and you need to modify the IP address of your PC to the same
network segment as the VTO to log in again.
6.1.2 HTTPS
Select the Enable check box at HTTPS Port, and then the VTO will reboot. After rebooting, you
can log in the VTO by entering "https:// VTO IP address" in the address bar of the explorer.
FTP 6.2
Configure FTP server, and then you can save the recorded videos and snapshots to the FTP
server.
Select Network Setting > FTP. Step 1
The FTP interface is displayed. See Figure 6-2.
To Next Page
Loading...
Need help?
General