Household Setting 21
VTS management Figure 5-10
Click Add. Step 2
The Add interface is displayed. See Figure 5-11.
Add VTS Figure 5-11
On VTS, select Config > Advance Config, then enter the password (123456 by Step 3
default), and then select SIP Server, the VTS No. is displayed as User Name
(normally it is 888888XXX).
Configure the parameters, and for the detailed description, see Table 5-3. Step 4
Table 5-3 Add VTS configuration
The VTS number you configured for the target VTS.
The IP address of the target VTS.
Click Save, and then the added VTS is displayed. Click to modify IP address, and Step 5
click to delete.
Select Local Setting > Basic, then enter the VTS No. of the added VTS at Center Call Step 6
No., and then you can call the VTS by pressing the call center button on the VTO. See
Figure 5-12.
To Next Page
Loading...