7
Step 2 to batch add room no.
Parameter with * are mandatory.
Step 5. Set network info.
a) In page, select System Config>Network Config.
b) Set VTO IP address, subnet mask and default gateway. After you are dome,
WEB page will reboot and go to the new set page. See Figure 3- 9.
Figure 3- 9
Note:
Please refer to Ch 5.
3.2.3 Analog VTH
4.3 inch VTH: plug it to power and long press call button, wait until it VTH enters room no.
set page. Press SOS button to select digit, and switch number and confirm via call button.
Then, VTH will reboot.
7 inch VTH: plug it to power and long press call button, wait until it VTH enters room no.
set page. Press SOS button to select digit, and switch number and confirm via call button.
Then, VTH will reboot.
Note: For more than one VTH, please set one by one!
For more config, please refer to VTO user’s manual.
To Next Page
Loading...
Need help?
General
