Dahua VTO12 Series User Manual

5
5.2.1 Local Config
5.2.1.1 Local Config
In page, select System Config>Local Config. Set parameter, and click on OK. See Figure
5- 2.
Figure 5- 2
Parameter
Note
Device Type
Display device type.
Video Format
Set collected video format by camera, including：WVGA, D1.
WVGA resolution si 800×480；D1 resolution is 704×576.
Reboot Date
In set date, device will reboot.
Frame Rate
Set NTSC to 30 and PAL to 25.
Password Unlock
Type
Includes self password and uniform password.
Project Password
Password to enter project setting page. Default is 888888.
Unlock
Responding
Interval
Unlock, after this interval device will respond again. Unit is second.
Door Sensor
Check Time
Only use door sensor, check Check Door Sensor Signal Before Lock and
set door sensor check time to enable it.
When unlock time out, door sensor will alarm.
Check Door
Sensor Signal
Before Lock
Unlock Period
Time that door lock remains unlocked. Unit is second.
Issue Card
Password
Default is 123456.
FTP IP, FTP port,
FTP user, FTP
password.
FTP server is used to store picture taken when swipe card at VTO. User can
log in FTP to get these pictures.

Dahua VTO12 Series Specifications

General

Brand	Dahua
Model	VTO12 Series
Category	Intercom System
Language	English