Dahua VTO2111D-WP

3
Please refer to Ch 5.2.4.2 for FTP setup.
Device Type Display device type. Now it is “villa station”.
Reboot Date On the set date, device will automatically reboot.
Default is 2:00 a.m.
Tuesday.
Version Info Display device version info.
Dial Rule There are serial and non-serial.
Default Only restore current Local Config page to default settings.
Refresh Click Refresh to refresh current interface.
OK Click OK to save.
Chart 5-1
5.2.1.2 A&C Manager
A&C Manager mainly controls unlock responding interval time, unlock period and door
sensor check time.
Go to System Config>Local Config>A&C Manager. See Figure 5-4 and Chart 5-2.
Figure 5-4
Parameter
Note
Unlock Responding
Interval
The interval between current unlock and ne
xt one,
unit is second.
Unlock Period
Period door remains unlocked, unit is second.
Door Sensor Check
Time
When only use
door sensor, check”Check Door
Sensor Signal Before Lock”, Set “Door Sensor Check
Time” to enable it.
When door remains unlocked ove
r set door sensor
check time, it alarms.
Check Door Sensor
Signal Before Lock
Auto Snapshot Select Enable, when you swipe card, it auto snapshot
two pictures and upload them to FTP or SD card.
Upload Unlock Record Select Enable, upload unlock record. You can view in
Info Search>Unlock Record> VTO Unlock Record.
Issue Card Authorize IC card unlock right, convenient for user to