Dahua VTO2111D-WP User Manual

7
system, so if you want to restore card info or VTH info, you must
operate within this time limit.
Export
Export config file（Config.backup）
Import config file.
Import
Default Restore all parameters to default status.
Chart 5-4
5.2.2 LAN Config
Go to System Config>LAN Config>LAN Config, see Figure 5-8.
Here you can register VTO to center and set how to call center. Please refer to Ch 5.1.1.
Figure 5-8
Parameter
Note
Building No.
Set villa VTH building no. and unit no.
Building Unit No.
VTO No.
Default is 6901. If connects to more than one VTO, enter 6901,
6902, 6903 and so forth.
Max Extension Index
1 VTH supports 5 extensions, and fill in extension according to
actual condition.
Warning:
When number of extension changes, you shall reboot VTH, and
configure VTH again.
Group Call Check “Group Call” box to call all VTHs, in this room.
MGT Center IP Address
Enter IP address and port no. of MGT center, check “Register to

Dahua VTO2111D-WP Specifications

General

Brand	Dahua
Model	VTO2111D-WP
Category	Intercom System
Language	English