6
Parameter Note
DST Enable
Check “DST Enable” box, to enable DST.
If you locate in place using DST, you can set DST accordingly. You can
select week mode or date mode to start and end DST.
DST Type
Start Time
Check “NTP Enable” box, to enable NTP server time sync function.
You can enter IP, zone, port no. and interval of PC where you installed NTP
server to set NTP.
Click “Default”, to restore default settings in this tab.
Click “Refresh” to refresh this page.
Chart 5-3
5.2.1.6 Config Manager
Go to System Config>Local Config>Config Manager, see Figure 5-7.
You can import and export configuration, or restore default setup.
Figure 5-7
Parameter Note
Backup
Check “card no.”, “VTH info”, and click
，so you can back up
card no. and VTH info.
Restore Backup Restore backup card info or VTH info.
During usage, if villa VTO is restored to default or card info is
abnormal, you can check Card Info box and click Restore Backup
to restore card info.
During usage, if you miss-modify VTH info, you can check VTH
info box and click Restore Backup to restore VTH info.
Warning:
Every half an hour, VTO auto saves card no. and VTH info in the
To Next Page
Loading...
Need help?
General
