SQLC-214-097
82
Appendix table 2
Active power range, watt-hour multiplier rate table (Single-phase 3-wire)
1000
1200
1500
1600
2000
2400
3000
4.00 k
5.00 k
6.00 k
8.00 k
×0.1
10.00 k
12.00 k
15.00 k
16.00 k
20.00 k
24.00 k
30.00 k
40.0 k
50.0 k
60.0 k
80.0 k
×1
100.0 k
120.0 k
150.0 k
160.0 k
180.0 k
200.0 k
240.0 k
300.0 k
320.0 k
360.0 k
400 k
500 k
600 k
800 k
×10
1000 k
1200 k
1500 k
1600 k
1800 k
2000 k
2400 k
3000 k
4.00 M
6.00 M
×100
40A
10A
12A
25A
30A
50A
60A
75A
[W]
15A
20A
6A
7.5A
8A
5A
80A
100A
120A
150A
200A
250A
300A
400A
500A
600A
750A
800A
5000A
7500A
1200A
1500A
2000A
2500A
1600A
1800A
3000A
4000A
1000A
900A
30000A
6000A
12000A
15000A
20000A
9000A
8000A
10000A
Multiplier
rate
V range
A range
150V
(110V)
<Note 1>
Parenthesis is primary active power (reactive power) value in /1kW(1kvar).
In the blank, setting is impossible.
About active power and reactive power range.
Full scale display, less than 4000：4 digit. More than 4000：3 digit.
An example) 4800kW → 4.80MW
40kvar → 40.0kvar
20kW → 20.00kW
<Note 2>
In case the voltage range and the current
range were set as
of an upper table
and an output pulse unit (a four-step setup
is possible) is set as the fastest.
The output pulse width of a pulse output is
set to 100 to 130ms. (Usually 240 to 260ms)
To Next Page
Loading...
