IM 930-6 •EnnityVerticalWaterSourceHeatPumps 40 www.DaikinApplied.com
Unit Check / Equipment Data
Installation Data
Job Name ___________________________________________________ CheckTestDate:__________________________
City__________________________________________________________ State _______________ Zip______________
Daikin Model # ______________________________________________________
Daikin Serial # _______________________________________ JobsiteUnitID#(HP#)_____________________________
General Contractor:_____________________________________ MechanicalContractor:_____________________________
Technician Performing Start-Up: Name______________________________ Employer:_____________________________
Complete equipment data from measurements taken at the locatons indicated on the drawing below.
Equipment Data
Flow Rate EWP - LWP = ∆P
EWP-PSIIn_________________minus LWP-PSIOut __________ equals∆P____________
TherststepinndingGPMistosubtractleavingwaterpressurefromenteringwaterpressure.Thedifferencebetweenthetwo
isreferredtoas∆P.∆PcanbeconvertedtoGPMbylookingintheequipmentspecicatoncatalog.Caution ∆P ≠ GPM
Note: A conversion table must be used to nd GPM from (Delta) ∆P measurements.
Loop Fluid Temperature Rise/DropthroughCoaxialHeatExchanger EWT - LWT = ∆T
EWT-°FOut_________________ minus LWT-°FOut__________________ equalsFluid∆T _______________
∆TistheriseordropintheuidtemperatureasitpassesthroughtheCoaxial.
Air Temperature Rise/Dropthroughtheaircoil ∆T x CFM x 1.08 = BTUH Sensible
EAT-°FIn___________________ minus LAT-°FOut___________________ equalsAir∆T_________________
Note: Perform Check, Test and Start-Up in the Cooling Mode Only.
EWT- EnteringWaterTemperature EWP- EnteringWaterPressure EAT- EnteringAirTemperature ∆-Delta(Differential)
LWT - LeavingWaterTemperature LWP - LeavingWaterPressure LAT - LeavingAirTemperature CFM - CubicFeet/Minute
BTUH- BritishThermalUnits/Hour
A
I
R
C
O
I
L
V
V
V
V
V
V
Discharge
HotGas
Suction
Compressor
Reversing Valve
V
COAX
IN OUT
LWP
LWT
Loop Fluid Pressure (In PSI) EWP
Loop Fluid Temperature °F EWT
EAT
Air Temperature °F
LAT
IN
OUT
Expansion
Valve
Check, Test & Start
1
3
2
4
5 6
1 2
3
4
5
6
Form No. ____________________________