Service Check Function SiENBE04-512A
98 Service Diagnosis
3. Service Check Function
In the ARC433A series remote control, the temperature display sections on the main unit
indicate corresponding codes.
Check Method 1 1. When the timer cancel button is held down for 5 seconds, a “00” indication flashes on the
temperature display section.
2. Press the timer cancel button repeatedly until a continuous beep is produced.
The code indication changes in the sequence shown below, and notifies with a long beep.
Note: 1. A short beep and two consecutive beeps indicate non-corresponding codes.
2. To cancel the code display, hold the timer cancel button down for 5 seconds. The code
display also cancels itself if the button is not pressed for 1 minute.
No. Code No. Code No. Code
1 OO 12 C7 23 HO
2 U4 13 H8 24 E1
3 F3 14 J3 25 P4
4 E6 15 A3 26 L3
5 L5 16 A1 27 L4
6 A6 17 C4 28 H6
7 E5 18 C5 29 H7
8 F6 19 H9 30 U2
9 C9 20 J6 31 UH
10 UO 21 UA 32 EA
11 E7 22 A5 33 AH
(R3038)
<
ARC433A1, A2
>
TIMER CANCEL button
It cancels the timer setting.
SiENBE04-512A.book Page 98 Friday, October 5, 2007 1:49 PM
To Next Page
Loading...
