Daikin FTKS20CVMB(9) - Removal of Switch Box, PC Board and Swing Motor

Indoor Unit SiENBE04-512A
148 Removal Procedure
1.4 Removal of Switch Box, PC Board and Swing Motor
Procedure Warning Be sure to wait 10 minutes or more after turning off all power
supplies before disassembling work.
Step Procedure Points
 Remove front grill.
1. Remove switch box.
1
Disconnect the
connection wires.
2
Disconnect connectors
(S1 and S7) of fan
motor.
 Pay attention to the direction
of the retainer of the
thermistor so that the
retainer will not touch the
harness (same as the
existing models.)
3
Disconnect one
connector (S6) of swing
motor.
4
Remove heat
exchanger thermistor.
Earth screw
Terminal strip
Swing motor
Heat exchanger
thermistor
S1
S7
S6
(R2528)
PC Board
Pl
ate of
connection
wires
(R2529)
Heat exchanger
thermistor
S1
Fan motor
S7
Connector of
fan motor
S6
Connector of
swing motor
(R2530)
Retainer of
thermistor
SiENBE04-512A.book Page 148 Friday, October 5, 2007 1:49 PM