Daikin FTKS20CVMB(9) - To Use on Timer Operation; To Combine on Timer and off Timer

Instruction SiENBE04-512A
86 System Configuration
ATTENTION
 To use ON TIMER operation
• Check that the clock is correct. If not, set the
clock to the present time.
1. Press “ON TIMER button”.
• 6:00 is displayed.
•“ “blinks.
2. Press “TIMER Setting button” until the time
setting reaches the point you like.
• Every pressing of either button increases or
decreases the time setting by 10 minutes.
Holding down either button changes the
setting rapidly.
3. Press “ON TIMER button” again.
• The TIMER lamp lights up..
 To cancel the ON TIMER operation
4. Press “CANCEL button”.
• The TIMER lamp goes off.
 To combine ON TIMER and OFF TIMER
• A sample setting for combining the two timers is
shown below
 In the following cases, set the timer again.
• After a breaker has turned OFF.
• After a power failure.
• After replacing batteries in the remote control.
ON
OFF
Display
(Example)
Present time: 11:00 p. m.
(The unit operating)
OFF TIMER at 0:00 a.m.
ON TIMER at 7:00 a.m.
Combined
SiENBE04-512A.book Page 86 Friday, October 5, 2007 1:49 PM