Daikin iTM plus - Removal from DIN Rail

24
Installation Manual 3P291714-4
DCM601A72 iTM plus adaptor
English
Place the iTM plus adaptor over the top of the DIN rail so that the upper hook (1) on the
rear face is hooked and push it in direction (3) until the lower hook (2) snaps into the DIN
rail. When done, remove the blue protective lm from the upper portion of the unit body.
(3)(3)
(2)(2)
(1)(1)
3.2.1 Removal from DIN rail
Pull down the lever at the lower portion of the iTM plus adaptor (1) and pull the unit body
(2) out toward you.
(1)(1)
(2)(2)
01_EN_3P291714-4.indd 24 3/26/2012 5:00:47 PM