44
Aux Humidifier and Dehumidifier Wiring
» Aux dehumidifiers and humidifiers are supported in Unitary systems.
» The thermostats aux outputs are dry contacts that close the
connection to turn on the aux equipment.
» A 24V AC control signal must be routed through one of the aux
contacts of the thermostat.
» An aux humidifier and/or aux dehumidifier can be added to the
thermostat in the “Equipment Setup” menu using “add equipment”.
– An aux humidifier controlled directly by the thermostat will
generally operate at the same time as any humidifier directly
connected to the indoor air handler or gas furnace. Only one
humidifier should be associated with a system.
– An aux dehumidifier controlled directly by the thermostat
operates along with any dehumidification function in an air
conditioning system.
Two accessories can be connected tp either pair (aux 1/1c or aux 2/2c) of terminals
*
.
*
The terminals are selected in the Daikin One+ installer wizard.
Note: It is recommended to use a minimum of 18-Gauge wire.
Maximum operating length of wire is 125 ft.
A 24VAC control signal must be routed through the aux contacts.
Accessory Hookup to
Daikin One+ Smart Thermostat
Daikin One+
Smart Thermostat
Begin Set-up / Equipment Set-up (cont'd)
To Line Voltage
To Next Page
Loading...
