Daikin SA R32 Sky-Air RZAG-L - Figure 3-25: Stripping the Main PCB Assembly (Front)

ESIE16-03B | Part 3. Repair 3.3. Unit specific repair procedures
22/08/16 | Version 1.1 Page 91
SA R32 Sky-Air RZAG-L
19. Loosen and remove the 3 screws (5) that fix the wiring.
20. Loosen and remove the 2 screws (6) that fix the wiring.
21. Loosen and remove the 2 screws (7) that fix the wiring.
22. Disconnect the 3 connectors (8) from the terminal block.
23. Loosen and remove the 2 screws (9) that fix the terminal block.
Figure 3-25: Stripping the main PCB assembly (front)
24. Loosen and remove the 2 screws (1) that fix the wiring.
25. Cut the 2 tie wraps (2) that fix the wiring.
26. Unlock the 9 standoffs (3) that fix the electrical noise filter PCB.
27. Remove the wiring from the cable clamp (4).
28. Remove the electrical noise filter PCB (5).
1. Tie wrap 6. Screw
2. Protection sheet 7. Screw
3. Tie wrap 8. Plug
4. Screw 9. Screw
5. Screw
1
1
2
3
3
4
6
45
6
7
9
9
8