To Next Page
E
Elizabeth SolomonAug 16, 2025
What to do if a refrigerant leak occurs (error code / ) in my Daikin SV1A25AJV1B?
- AAustin RiddleAug 16, 2025
Notify your installer and report the malfunction code.
What to do if a refrigerant leak occurs (error code / ) in my Daikin SV1A25AJV1B?
Notify your installer and report the malfunction code.
What to do if my Daikin Air Conditioner system does not operate at all?
If your Daikin Air Conditioner system isn't operating, first check for a power failure and wait until power is restored. The system restarts automatically after power is restored if the failure occurred during operation. Also, check if a fuse has blown or a breaker has been activated. Replace the fuse or reset the breaker if necessary.
What to do if my Daikin Air Conditioner goes into fan only operation then stops when heating or cooling is enabled?
If your Daikin Air Conditioner goes into fan-only operation and then stops when switching to heating or cooling, check if the air inlet or outlet of the outdoor or indoor unit is blocked. Remove any obstacles to ensure free airflow. Also, verify that the user interface display is showing on the home screen, referring to the installation and operation manual delivered with the indoor unit.
What to do if the Daikin SV1A25AJV1B user interface display indicates a unit number, the operation lamp flashes, and a malfunction code appears?
Notify your installer and report the malfunction code.
What to do if Daikin Safety Equipment system does not operate at all?
If your Daikin Safety Equipment system isn't working, first ensure there is no power outage and wait for the power to be restored, as the system restarts automatically after a power failure. Also, check the fuse and breaker; replace the fuse or reset the breaker if necessary. If the issue continues, it is recommended to contact your installer.
What to do if Daikin Safety Equipment has a refrigerant leak?
If your Daikin Safety Equipment system indicates a refrigerant leak (error code / ), allow the system to take actions. Do not turn off the power. Report the error code to your installer.
What to do if Daikin Safety Equipment unit leaks water?
If water is leaking from your Daikin Safety Equipment unit, stop the operation immediately. Then, contact your installer.
Why is my Daikin SV1A25AJV1B Air Conditioner not cooling or heating enough?
There are several reasons why your Daikin Air Conditioner might not be cooling or heating sufficiently: * The air inlet or outlet of the outdoor or indoor unit might be blocked by obstacles. Remove any obstacles to ensure free airflow. * The air filter might be clogged. Please refer to the 'Maintenance' section in the indoor unit manual to check and clean it. * The temperature setting might be incorrect. Adjust it as needed. * The fan speed setting might be set too low on your user interface. Increase the fan speed. * Doors or windows might be open, letting wind in. Close them. * There might be too many people in the room or excessive heat sources. * Direct sunlight might be entering the room. Use curtains or blinds. * The airflow angle might not be proper. Adjust it for ...
General| Model | SV1A25AJV1B |
|---|---|
| Cooling Capacity | 2.5 kW |
| Heating Capacity | 3.2 kW |
| Refrigerant | R32 |
| Power Supply | 220-240V, 50Hz |
| Indoor Unit Noise Level | 19 dB |
