Spyder3 GigE Vision User’s Manual
DALSA 03-032-20027-02
33
[GPIOSelector]
GPIOSelector GPIO selector for sgi and sgo.
Height This feature represents the actual image height expelled by the
camera (in pixels).
Min 1, Max 16383
LedStatus gls get status led. Returns the current state of the cameras LED
where: 1: Red, 2: Green, 5: Blinking green, 6: Blinking red
LoadPixelCoefficients lpc Load PRNU and FPN coefficients from cameras non-volatile
memory.
LowerThresholdLimitRaw slt Set lower threshold
Min 0, Max 4095
PixelFormat sdm This feature indicates the format of the pixel to use during the
acquisition.
PixelSetSelector Selector for the FFC Coefficient Set
ReadoutMode srm set readout mode. Use this command to clear out dark current
charge in the vertical transfer gates immediately before the
sensor is read out.
ResetPixelCoefficients rpc reset pixel coeffs. Resets the pixel coefficients to 0.
RestoreFactorySettings rfs restore factory settings. Restores the cameras factory settings.
FPN and PRNU coefficients reset to 0.
RestoreUserSettings rus restore user settings. Restores the camera's last saved user
settings and FPN and PRNU coefficients.
SensitivityMode ssm Set sensitivity mode
SensorDigitizationTaps This feature represents the number of digitized samples
outputted simultaneously by the camera A/D conversion stage.
SensorShiftDirection scd CCD sensor shift direction. NOTE: only available when
SensitivityMode is 1.
SensorWidth This feature indicates the effective width of the sensor in pixels.
SubtractBackgroundRaw
[SubtractBackgroundSelector]
ssb Set Subtract Background 1-4096. Subtract the input value from
the output signal.
Min 0, Max 4095
SubtractBackgroundSelector selector for SubtractBackground
TestImageSelector svm This feature selects the type of test image that is expelled by the
camera.
UpdateGainReference ugr update gain reference. Changes 0dB gain to equal the current
analog gain value set with the sag command.
UpperThresholdLimitRaw sut Set upper threshold
Min 0, Max 4095
Width This feature represents the actual image width expelled by the
camera (in pixels).
Min 8, Max 4096
WriteFPNCoefficients wfc Write FPN coefficients to cameras non-volatile memory.
WritePRNUCoefficients wpc Write PRNU coefficients to cameras non-volatile memory.
WriteUserSetting wus NOTE: this feature will be available soon. write user settings.
Save user setting.
To Next Page
Loading...
Need help?
General
