Spyder3 GigE Vision User Manual
03-032-20027-02 DALSA
60
Returning the LED Status
Returns the status of the camera’s LED.
LEDStatus
The camera returns one of the following values:
Red (loss of functionality)
Green (camera is operating correctly)
Flashing green (camera is performing a function)
Flashing red (fatal error)
5.10 Error Handling
The following table lists warning and error messages and provides a description and
possible cause.
Warning messages are returned when the camera cannot meet the full value of the
request; error messages are returned when the camera is unable to complete the request.
Table 12: Warning and Error Messages
Message Description
OK> SUCCESS
Warning 01: Outside
of specification>
Parameter accepted was outside of specified operating range (e.g. gain
greater than ±10 dB of factory setting).
Warning 02: Clipped
to min>
Parameter was clipped to the current operating range.
Warning 03: Clipped
to max>
Parameter was clipped to the current operating range.
Warning 04: Related
parameters
adjusted>
Parameter was clipped to the current operating range.
Warning 05: Can’t
set LVDS for this
GPIO signal
Input 3 and Output 3 cannot be set to use an LVDS signal.
Warning 07:
Coefficient may be
inaccurate A/D
clipping has
occurred>
In the region of interest (ROI) greater than 6.251% single or 1% of
averaged pixel values were zero or saturated.
Warning 08: Greater
than 1% of
coefficients have
been clipped>
A FPN/PRNU has been calculated to be greater than the maximum
allowable 511 (8).
Warning 09: Internal
line rate inconsistent
with readout time>
To Next Page
Loading...
Need help?
General
