Spyder3 GigE Vision User’s Manual
DALSA 03-032-20027-02
71
Appendix B
ASCII Commands
All the functionality available through the QuickCam GUI is also available through the
serial interface using the camera-specific three letter commands.
There are three ways to enter ASCII commands: (1) through the QuickCam Command
tab, (2) through the Configuration window, or (3) through the virtual serial port. Entering
commands through the QuickCam Command window is the simplest method.
Command Window Method:
1. Open QuickCam.
In the Message Window:
2. Open the Command tab.
3. At the OK> prompt, enter the ASCII command. Refer to Appendix A for details on all
of ASCII commands available with this camera.
4. Press Enter.
The camera responds with OK> if the command was successful or an error or warning
message as appropriate.
To Next Page
Loading...
Need help?
General
