22
SPEED SENSOR INSTALLATION
Dana Incorporated TSM-0238 - 6000 Transmission Service Manual
SPEED SENSOR INSTALLATION
SPEED SEN SOR INSTAL LATION
The magneto resistive sensor generates a square wave current with a fixed amplitude changing between 7 mA and 14 mA. The
sensor has an integrated AMP superseal 2-pin connector. The two pins are numbered 1 and 2.
The following table shows the relation between wire color, pin number and connection.
Pin. Function Connection
1. Current Input Hot Wire
2. Current Output Ground Wire
The sensor wires have a polarity. Be sure to correctly observe sensor polarities as wrong connections will deactivate the sen-
sor!.
Speed Sensor
Speed Sensor Bushing
Torque 61-68 N-m
Plug
Torque 16-20 N-m
To Next Page
Loading...
