Dancutter DC SUPER FLEX - Clean Behind Arm;Swivel Support; Clean the Forward;Back Drive

27
20-06-2023 50400 >
In the event of new product developments, Dancutter reserves the right to change the technical description without advance notice.
Authorised Representative in the United Kingdom: Mini-Cam Limited Unit 33, Ravenscraig Road, Little Hulton, Salford, M38 9PU.
© Copyright 2021 Dancutter A/S. Dancutter A/S is a Halma Company. Dancutter A/S, Livøvej 1 A, DK-8800 Viborg, +45 9651 2150, info@dancutter.dk, dancutter.com
• Raise the arm all the way up and clean the space behind the
swivel support with compressed air. Next, lubricate the
piston and swivel support, insert with oil and re-lower the
arm.
· Clean with compressed air under the lid by the camera
outlet.
CLEAN WITH COMPRESSED AIR
LUBRICATE
CLEAN WITH COMPRESSED AIR AND
DRY WITH PAPER AND CLOTH
(POSSIBLY WITH A SMALL SCREWDRIVER IN THE TRACKS).
8.3 Clean behind arm/swivel support
• Clean the forward/back drive with compressed air. Fully
extend the unit and clean its tracks and edges.
• After cleaning, do NOT lubricate the forward/back drive unit
with oil or grease, as grime and dirt will stick to it and im-
pede its movement. If the cutter gets scratched and
becomes leaky, water will be able to penetrate the section
from the outside. Therefore, keep this section CLOSED
whenever the cutter is being pushed forward or backwards
in the pipeline.
8.4 Clean the forward/back drive