Dancutter DC SUPER FLEX - Clean Underneath the Cover; Grinder; 8 Service and Maintenance

26
20-06-2023 50400 >
In the event of new product developments, Dancutter reserves the right to change the technical description without advance notice.
Authorised Representative in the United Kingdom: Mini-Cam Limited Unit 33, Ravenscraig Road, Little Hulton, Salford, M38 9PU.
© Copyright 2021 Dancutter A/S. Dancutter A/S is a Halma Company. Dancutter A/S, Livøvej 1 A, DK-8800 Viborg, +45 9651 2150, info@dancutter.dk, dancutter.com
8.0 Service and maintenance
8.1 Grinder
• Clean with compressed air underneath the cover next to the
camera outlet.
• Dismantle the cover if necessary.
• Clean the grinder with water or compressed air.
• Unscrew the hex screw in the end of the grinder (GRS),
add a drop of blue grease to the screw hole and re-attach
the screw. Once a week or as needed.
• After operating the grinder in a very damp environment
or if it will be idle for an extended period of time, remove the
grinder and drip oil into the coupling nipple and evenly dis
tribute the oil in the motor by blowing it with an air gun. This
will displace any water/moisture.
BLUE GREASE (F85001)
DISMANTLE THE COVER
8.2 Clean underneath cover