Dancutter DC SUPER FLEX - Clean the Rotation Function; Maintaining the Control Unit

28
20-06-2023 50400 >
In the event of new product developments, Dancutter reserves the right to change the technical description without advance notice.
Authorised Representative in the United Kingdom: Mini-Cam Limited Unit 33, Ravenscraig Road, Little Hulton, Salford, M38 9PU.
© Copyright 2021 Dancutter A/S. Dancutter A/S is a Halma Company. Dancutter A/S, Livøvej 1 A, DK-8800 Viborg, +45 9651 2150, info@dancutter.dk, dancutter.com
CLEAN THE GROOVE WITH COMPRESSED AIR
• Remove sand and dirt by blowing compressed air into the
thin groove.
• Continuing to use the rotation function if this groove is dirty
will needlessly overload the rotation motor. It can also cause
a defect in the rotation motor or damage components in the
control unit.
• Avoid getting water/moisture on the control unit, as it is not
watertight. Close it after use and hang it on the hose reel to
protect the screen and switches.
• Always replace caps on CABLES AND CONTROL UNIT after
use to protect the power outlets.
• Always hang the control unit in place after use.
8.5 Clean the rotation function
8.6 Maintaining the control unit