Dancutter DC SUPER FLEX - Service Overview

31
20-06-2023 50400 >
In the event of new product developments, Dancutter reserves the right to change the technical description without advance notice.
Authorised Representative in the United Kingdom: Mini-Cam Limited Unit 33, Ravenscraig Road, Little Hulton, Salford, M38 9PU.
© Copyright 2021 Dancutter A/S. Dancutter A/S is a Halma Company. Dancutter A/S, Livøvej 1 A, DK-8800 Viborg, +45 9651 2150, info@dancutter.dk, dancutter.com
8.9 Service overview
Service overview
Part - components - service Daily Weekly Other
Cleaning the cutter. x
Check pneumatic oil. See 7.1.1 (5). Add oil as needed. See 7.1.1 (8). x
Clean and lubricate the piston and swivel support unit insert. See 8.3. x
Lubricate the Grinder. See 8.1. x x
Visually inspect the cutter. Inspect screws, adapter, cutting tools, etc., for
wear and damage and replace or tighten them if necessary.
x
Lubricate with grease in the grease nipple. See 8.7 (once or twice a year) As required
Addwasheruid.See7.1.2 As required
Replaceairlter.See7.1.1(4) As required
Cleaning the grabber x
Lubricate grabber with a drop of pneumatic oil on each arm and move the
arms up and down a couple times
x