10
There are three options for mounting the ERC 102
in a freezer or refrigerator.
SAFETY INFO
Risk of electrocution!
For mounting: Do not connect mains power until
the controller is correctly mounted.
For unmounting: Disconnect the power supply
before unmounting.
4. MOUNTING
1. Insert the ERC 102 into the cabinet.
2. Attach the clips to each side of the ERC 102.
3. Place the front frame on to the ERC 102 and click
it into place.
4. Connect the sensors and outputs as required and
then the power cable (see Chapter 6 – parameters
for information about programming which inputs
and outputs are applicable to your configuration).
4.1 Rear mounting – Option 1
ERC 102 Reference manual – 4 MOUNTING
To Next Page
Loading...
