13
1. Use a flat head screwdriver (ideally the
one supplied with the ERC 102 sample package)
and insert it carefully between the front frame
and the controller.
3. Cabinet. Do not use a different type of
screwdriver or a sharp item such as a knife
which risks causing damage.
4.2.1 Unmounting
4.3 Fully integrated design – Option 3
An option is available for OEMs wanting to use the ERC
102 in a fully-integrated design. Please contact your
local Danfoss representative for more information.
2. Gently twist the screwdriver to remove the
front frame. Do this in four places next to each
clip area.
ERC 102 Reference manual – 4 MOUNTING
To Next Page
Loading...
