Danfoss ERC 102 User Manual

7
2.3 Connections
Programming an individual unit in a laboratory:
the USB gateway requires KoolProg Software
running on a PC. It enables parameters to be set in
real time and an array of status information to be
read (bidirectional connection). This method is used
to determine the correct parameters during R&D.
Once the desired settings have been determined,
a KoolProg ERC specific parameter file is saved to the
EKA183 USB copy key for later mass programming.
The USB Gateway is a laboratory tool, offering fast
and easy programming of any ERC102 controller.
KoolProg software installation is provided;
the gateway is standard inventory for OEM labs.
Mass programming on an assembly line:
the docking station is used for high volume
programming of ERC controllers, for example
on an assembly line. The docking station is a
write-only device.
See above (Programming an individual unit) for
preparing the EKA183 USB copy key, which is to
be inserted into the docking station. The settings
are then loaded into each successive controller
in a matter of seconds.
KoolProg software is not required for mass
programming.
Note: please refer to the koolprog manual for more
details about programming.
KoolProg: is the software from Danfoss for
programming the ERC 102 via a USB cable and
a PC rather than with the front panel buttons.
Please refer to the KoolProg manual for details.
ERC 102 Reference manual – 2 CONTENT OF THE BOX

Danfoss ERC 102 Specifications

General

Brand	Danfoss
Model	ERC 102
Category	Controller
Language	English