What to do if my Danfoss MCA 122 Modbus TCP DC Drives has cabling mis-configuration?
If your Danfoss DC Drives unit indicates a cabling mis-configuration, you should exchange the cable in doubt and verify that the option has a valid IP address.
Outlines Danfoss's copyright, liability limitations, and rights to revise the publication.
Lists mandatory safety practices and precautions for operating the frequency converter.
Details risks and precautions to prevent accidental starting of the motor.
Provides essential information for quick installation and setup, and details for further study.
Outlines prerequisites, assumed knowledge, and scope of the manual for Modbus Option Card.
Lists related documents and confirms compliance with Modbus standards.
Lists and defines abbreviations used throughout the manual for clarity.
Details the installation of the MCA 122 Modbus TCP option into the frequency converter.
Explains the function of the option's LEDs for module and network status.
Describes star and line topologies for connecting Modbus TCP options.
Covers Ethernet media selection, cable length, and design rules for reliable network operation.
Provides guidelines for minimizing electromagnetic interference for network operation.
Details parameters for configuring the option's IP address, subnet mask, and gateway.
Explains parameters related to the Ethernet link status, speed, and negotiation.
Guides on setting up a scanner (PLC) to communicate with the frequency converter.
Discusses important aspects of IP traffic for industrial automation networks.
Explains how to control the frequency converter using Modbus TCP messages.
Details the components and fields of a Modbus TCP message for communication.
Covers IND, text blocks, conversion factors, parameter values, and exception codes.
Describes the PROFIdrive control word (CTW) for sending commands to the slave.
Explains the PROFIdrive status word (STW) for notifying the master about the slave's status.
Illustrates state transitions for the PROFIdrive control profile.
Details how to manage speed references, including bus speed value scaling.
Describes the control word for the Danfoss FC profile, including bits and explanations.
Explains the FC status word (STW) for notifying the master about the frequency converter's status.
Details settings for control site, control word source, timeout functions, and end-of-timeout actions.
Covers IP settings, Ethernet link parameters, process data, and Modbus TCP configurations.
Configures FTP, HTTP, SMTP services, cable diagnostics, and network storm protection.
Provides a comprehensive list of parameters with their default values and types.
Explains data types and provides a conversion index for parameters.
Provides a guided approach to diagnose and resolve issues with LEDs, link status, cabling, and IP address.
Explains how alarm and warning words are displayed and their meaning.
To Next Page
General