Inspection
Inspect the shaft journals for wear, scratching, and pits. Check the splines for fretting; replace if
damaged. Rotate the bearing, if it does not rotate smoothly, replace it.
Shaft Reassembly
1. Press the bearing (J150) onto the shaft (J100) and replace the retaining ring (J200).
2. Install the shaft/bearing assembly into the pump.
3. Install first spring clip (J300).
4. Cover the shaft with a protective sleeve while installing the seal. Lubricate and install the seal.
5. Install the second spring clip (J300).
Service Manual
MP1
Minor repair
©
Danfoss | April 2019 AX00000244en-000201 | 63
To Next Page
Loading...
