Danfoss vlt aqua Instruction

Motor Bearing Currents 4-52
Motor Cable 4-44
Motor Current 1-24 6-15
Motor Nameplate 4-61
Motor Nominal Speed 1-25 6-16
Motor Output 8-1
[Motor Power Kw] 1-20 6-15
Motor Protection 8-4
[Motor Speed High Limit Rpm] 4-13 6-20
[Motor Speed Low Limit Rpm] 4-11 6-20
Motor Thermal Protection 4-64
Motor Voltage 1-22 6-15
N
Nameplate Data 4-61
Namur 4-31
Network Connection 7-2
No-flow Delay 22-24 6-36
No-flow Function 22-23 6-35
No-flow Power 22-30 6-36
Non-ul Compliance 4-49
O
Occurrence 23-04 6-46
Off Action 23-03 6-45
Off Time 23-02 6-45
On Action 23-01 6-44
On Time 23-00 6-43
Operation/display 6-66
Output Performance (u, V, W) 8-1
P
Parallel Connection Of Motors 4-63
Parameter Options 6-48
Parameter Selection 6-7
Parameter Set-up 6-1
Parameter Values 7-12
Pc Software Tools 5-11
Pid Integral Time 20-94 6-34
Pid Normal/inverse Control, 20-81 6-33
Pid Proportional Gain 20-93 6-34
[Pid Start Speed Rpm] 20-82 6-33
Pipe Fill Enable, 29-00 6-47
Pipe Fill Rate, 29-04 6-47
[Pipe Fill Speed Hz], 29-02 6-47
[Pipe Fill Speed Rpm], 29-01 6-47
Pipe Fill Time, 29-03 6-47
Planning The Installation Site 4-2
Potentiometer Reference 4-57
Power Connections 4-33
Power Correction Factor 22-31 6-36
Preset Reference 3-10 6-17
Pressure At No-flow Speed 22-87 6-42
Pressure At Rated Speed 22-88 6-42
Profibus Dp-v1 5-11
Protection 4-49
Protection And Features 8-4
Protocol Overview 7-4
Pulse Inputs 8-2
Pulse Start/stop 4-56
Index
VLT AQUA Low Harmonic Drive Instruction
Manual
10-4 MG.20.T1.22 - VLT
®
is a registered Danfoss trademark

Danfoss vlt aqua Specifications

General

Supply Voltage	200-240V, 380-500V, 525-600V
Enclosure	IP20
Features	Energy optimization
Approvals	CE, UL, cUL
Input Voltage Range	200-240V, 380-500V, 525-600V
Output Voltage Range	0 to supply voltage
Protection Features	Overvoltage, Undervoltage, Overcurrent, Short circuit, Ground fault
Communication Interfaces	PROFIBUS
Cooling Method	Air-cooled