Danfoss vlt aqua Instruction

1.1.3 Software Version and Approvals
VLT AQUA Low Harmonic Drive
Software version: 1.33
This manual can be used with all VLT AQUA Low Harmonic Drive adjustable frequency drives with software version 1.33.
The software version number can be found in parameter 15-43 on the drive LCP.
NOTE!
The VLT AQUA Low Harmonic Drive has two different LCPs, one for the adjustable frequency drive (to the right) and one for the active
filter (to the left). Each LCP controls only the unit it is connected to and there is no communication between the two LCPs
1.1.4 Symbols
Symbols used in this Instruction Manual.
NOTE!
Indicates something to be noted by the reader.
Indicates a general warning.
Indicates a high-voltage warning.
*
Indicates a default setting
1 How to Read the Instruction Manual
VLT AQUA Low Harmonic Drive Instruction
Manual
1-2 MG.20.T1.22 - VLT
®
is a registered Danfoss trademark
1

Danfoss vlt aqua Specifications

General

Supply Voltage	200-240V, 380-500V, 525-600V
Enclosure	IP20
Features	Energy optimization
Approvals	CE, UL, cUL
Input Voltage Range	200-240V, 380-500V, 525-600V
Output Voltage Range	0 to supply voltage
Protection Features	Overvoltage, Undervoltage, Overcurrent, Short circuit, Ground fault
Communication Interfaces	PROFIBUS
Cooling Method	Air-cooled