EasyManuals Logo
Home>Danfoss>DC Drives>VLT AutomationDrive FC 302

Danfoss VLT AutomationDrive FC 302 Installation Guide

Danfoss VLT AutomationDrive FC 302
82 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
1 Introduction
1.1 Purpose of this Installation Guide
This manual provides information for safe installation and commissioning of a VLT® Safety Option MCB 152 for PROFIsafe
communication
The Installation Guide is intended for use by qualified personnel only. Personnel must be familiar with the VLT
®
drive series.
Read and follow this Installation Guide before installation, and ensure that instructions for safe installation are observed. Always keep
these instructions available with the drive.
1.2 Trademarks
VLT
®
is a registered trademark for Danfoss A/S.
1.3 Additional Resources
More information resources are available to understand advanced drive functions and programming.
The VLT® AutomationDrive FC 301/FC 302 and the VLT® Decentral Drive FCD 302 Operating Guides provide information required to
install and commission the drive for given applications.
The VLT® PROFINET MCA 120 Installation Guide provides instructions on how to install the PROFINET option.
VLT® Motion Control Tool MCT 10 Operating Guide describes how to configure the safety option via the MCT 10 Set-up Software.
VLT® Frequency Converters Safe Torque Off Operating Guide describes the use of VLT® FC Series drives in functional safety
applications.
Technical documentation for other product options is available at
www.danfoss.com.
1.4 Document Version
This Installation Guide is regularly reviewed and updated. All suggestions for improvement are welcome.
The original language of this manual is English.
Table 1: Document Version
Revision Remarks
AN327351953089, version 0101 Now also available for VLT® Decentral Drive FCD 302.
Changed from Operating Guide to Installation Guide.
1.5 Product Overview
1.5.1 Intended Use
VLT® Safety Option MCB 152 is designed to activate and deactivate safety functions of a drive through the PROFIsafe fieldbus. Using
the fieldbus, requires the VLT® PROFINET MCA 120 option to be installed. The safety functions of the safety option are implemented
according to EN IEC 61800-5-2.
Introduction
Installation Guide | VLT®Safety Option MCB 152
AN327351953089en-000101 / 130R0578
6 | Danfoss A/S © 2020.02

Table of Contents

Other manuals for Danfoss VLT AutomationDrive FC 302

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Danfoss VLT AutomationDrive FC 302 and is the answer not in the manual?

Danfoss VLT AutomationDrive FC 302 Specifications

General IconGeneral
BrandDanfoss
ModelVLT AutomationDrive FC 302
CategoryDC Drives
LanguageEnglish

Related product manuals