Danfoss VLT FC 100 Series Programming Guide

[71] bar
[72] Pa
[73] kPa
[74] m WG
Power:
[80] kW
Flow, volume:
[120] GPM
[121] gal/s
[122] gal/min
[123] gal/h
[124] CFM
[125]
ft
3
/s
[126]
ft
3
/min
[127]
ft
3
/h
Flow, mass:
[130] lb/s
[131] lb/min
[132] lb/h
Velocity:
[140] ft/s
[141] ft/min
Length:
[145] ft
Temperature:
[160] ° F
Pressure:
[170] psi
[171]
lb/in
2
[172] in WG
[173] ft WG
Power:
[180] HP
0-31 Custom Readout Min Value
Range: Function:
0.00 * [0 - par. 32]
This parameter allows the choice of the min. value of the custom defined readout (occurs at zero speed). It is
only possible to select a value different to 0 when selecting a linear unit in
Custom Readout Unit , par. 0-30. For
Quadratic and Cubic units the minimum value will be 0.
0-32 Custom Readout Max Value
Range: Function:
100.00 * [Par. 0-31 - 999999.99 ]
This parameter sets the max value to be shown when the speed of the motor has reached the set value for
Motor
Speed High Limit
, (par.4-13/4-14).
0-37 Display Text 1
Option: Function:
In this parameter it is possible to write an individual text string for display in the LCP or to be read via serial
communication. If to be displayed permanently select Display Text 1 in par. 0-20, par. 0-21, par. 0-22, par. 0-23
VLT
®
HVAC Drive Programming Guide 3. Parameter Description
MG.11.C5.02 - VLT
®
is a registered Danfoss trademark 33
3

Danfoss VLT FC 100 Series Specifications

General

Brand	Danfoss
Model	VLT FC 100 Series
Category	DC Drives
Language	English