3.10. Main Menu - Profibus - Group 9
3.10.1. 9-** Profibus
Parameter group for all Profibus-specific parameters.
9-15 PCD Write Configuration
Array [10]
Select the parameters to be assigned to PCD 3 to 10 of the telegrams. The number of available PCDs depends
on the telegram type. The values in PCD 3 to 10 will then be written to the selected parameters as data values.
Alternatively, specify a standard Profibus telegram in par. 9-22.
None
[3-02] Minimum Reference
[3-03] Maximum Reference
[3-41] Ramp 1 Ramp Up Time
[3-42] Ramp 1 Ramp Down
Time
[3-51] Ramp 2 Ramp Up Time
[3-52] Ramp 2 Ramp Down
Time
[3-80] Jog Ramp Time
[3-81] Quick Stop Ramp Time
[4-11] Motor Speed Low Limit
[RPM]
[4-13] Motor Speed High Limit
[RPM]
[4-16] Torque Limit Motor
Mode
[4-17] Torque Limit Generator
Mode
[5-90 ] Digital & Relay Bus
Control
[5-93] Pulse Out #27 Bus
Control
[5-95] Pulse Out #29 Bus
Control
[6-53] Terminal 42 Output
Bus Control
[7-28] Minimum Feedback
[7-29] Maximum Feedback
[8-90] Bus Jog 1 Speed
[8-91] Bus Jog 2 Speed
[16-80] Fieldbus CTW 1
[16-82] Fieldbus REF 1
3. Parameter Description VLT
®
HVAC Drive Programming Guide
98
MG.11.C5.02 - VLT
®
is a registered Danfoss trademark
3
To Next Page
Loading...
