Danfoss vlt FC 102 Installation Guide

1 Introduction
1.1 Purpose of the Manual
This manual provides requirements for mechanical and
electrical installation of the VLT
®
Parallel Drive Modules
basic kit. Separate installation instructions for optional
components - bus bars and back-channel cooling - are
provided with those kits.
This guide includes information on:
•
Wiring of mains and motor connections.
•
Wiring of control and serial communications.
•
Control terminal functions.
•
Detailed tests that must be performed before
start-up.
•
Initial programming to verify proper functioning
of the drive system.
The installation guide is intended for use by
qualied
personnel.
To install the drive modules and paralleling kit safely and
professionally, read and follow the installation guide. Pay
particular attention to the safety instructions and general
warnings. Always keep this installation guide with the
panel containing the VLT
®
Parallel Drive Modules
components.
VLT
®
is a registered trademark.
1.2
Additional Resources
Other resources are available to understand functions and
programming of the VLT
®
Parallel Drive Modules.
•
The VLT
®
Parallel Drive Modules Design Guide
contains detailed information about the
capabilities and functionality of motor control
systems using these drive modules, and provides
guidance for designing this type of system.
•
The VLT
®
Parallel Drive Modules User Guide
contains detailed procedures for start-up, basic
operational programming, and functional testing.
Additional information describes the user
interface, application examples, troubleshooting,
and specications.
•
Refer to the Programming Guide applicable to the
particular series of VLT
®
Parallel Drive Modules
used in creating the drive system. The
programming guide describes in greater detail
how to work with parameters and provides
application examples.
•
The VLT
®
FC Series, D-frame Service Manual
contains detailed service information, including
information applicable to the VLT
®
Parallel Drive
Modules.
•
The VLT
®
Parallel Drive Modules DC Fuses Instal-
lation Instructions contain detailed information
about installing the DC fuses.
•
The VLT
®
Parallel Drive Modules Bus Bar Kit Instal-
lation Instructions contain detailed information
about installing the bus bar kit.
•
The VLT
®
Parallel Drive Modules Duct Kit Instal-
lation Instructions contain detailed information
about installing the duct kit.
Refer to other supplemental publications and manuals,
available from Danfoss. See drives.danfoss.com/knowledge-
center/technical-documentation/ for listings.
1.3 Document and Software Version
This manual is regularly reviewed and updated. All
suggestions for improvement are welcome. Table 1.1 shows
the document version and the corresponding software
version.
Edition Remarks Software
version
MG37K3xx Added 230 V external
power supply content
FC 102 (5.0x),
FC 202 (3.0x),
FC 302 (7.6x)
Table 1.1 Document and Software Version
1.4
Approvals and Certications
Table 1.2 Approvals and Certications
1.5
Disposal
Do not dispose of equipment containing
electrical components together with
domestic waste.
Collect it separately in accordance with
local and currently valid legislation.
Introduction
VLT
®
Parallel Drive Modules
4 Danfoss A/S © 08/2017 All rights reserved. MG37K302
11

Danfoss vlt FC 102 Specifications

General

Brand	Danfoss
Model	vlt FC 102
Category	DC Drives
Language	English