Danfoss VLT Flow Drive FC 111 - Page 46

N O T I C E
Changing the value of these parameters affects the setting of other parameters.
1-20 Motor Power
Default value: Configuration dependent
Parameter type: Option
2-setup: All setups
Conversion index: -
Data type: u_int8
Change during operation: False
Enter the nominal motor power in kW/hp according to the motor nameplate data. The default value corresponds to the nominal
rated output of the unit.
Table 47: Option:
[2]
0.12 kW - 0.16 hp
[3]
0.18 kW - 0.25 hp
[4]
0.25 kW - 0.33 hp
[5]
0.37 kW - 0.5 hp
[6]
0.55 kW - 0.75 hp
[7]
0.75 kW - 1 hp
[8]
1.1 kW - 1.5 hp
[9]
1.5 kW - 2 hp
[10]
2.2 kW - 3 hp
[11]
3 kW - 4 hp
[12]
3.7 kW - 5 hp
[13]
4 kW - 5.4 hp
[14]
5.5 kW - 7.5 hp
[15]
7.5 kW - 10 hp
[16]
11 kW - 15 hp
[17]
15 kW - 20 hp
[18]
18.5 kW - 25 hp
[19]
22 kW - 30 hp
[20]
30 kW - 40 hp
[21]
37 kW - 50 hp
[22]
45 kW - 60 hp
[23]
55 kW - 75 hp
[24]
75 kW - 100 hp
[25]
90 kW - 120 hp
[26]
110 kW - 150 hp
[27]
132 kW - 180 hp
AU363928304090en-000101 / 130R098246 | Danfoss A/S © 2021.07
Parameters
VLT® Flow Drive FC 111
Programming Guide