Danfoss VLT Flow Drive FC 111 - Page 47

[28]
160 kW - 215 hp
[29]
200 kW - 270 hp
[30]
250 kW - 340 hp
[31]
315 kW - 425 hp
[32]
355 kW - 480 hp
1-22 Motor Voltage
Default value: Configuration dependent
Parameter type: Range
2-setup: All setups
Conversion index: -
Data type: u_int16
Change during operation: False
Enter the nominal motor voltage according to the motor nameplate data. The default value corresponds to the nominal rated out-
put of the unit.
Table 48: Range:
Min: 50 V
Max: 1000 V
Default value: Configuration dependent
1-23 Motor Frequency
Default value: Configuration dependent
Parameter type: Range
2-setup: All setups
Conversion index: -
Data type: u_int16
Change during operation: False
Select the motor frequency value from the motor nameplate data.
Table 49: Range:
Min: 20 Hz
Max: 400 Hz
Default value: Configuration dependent
1-24 Motor Current
Default value: Configuration dependent
Parameter type: Range
2-setup: All setups
Conversion index: -2
Data type: u_int32
Change during operation: False
Enter the nominal motor current value from the motor nameplate data. This data is used for calculating motor torque, motor ther-
mal protection, and so on.
Table 50: Range:
Min: 0.01 A
Max: 1000.00 A
Default value: Configuration dependent
1-25 Motor Nominal Speed
Default value: Configuration dependent
Parameter type: Range
2-setup: All setups
Conversion index: -
Data type: u_int16
Change during operation: False
Enter the nominal motor speed value from the motor nameplate data. This data is used for calculating automatic motor compensa-
tions.
Table 51: Range:
Min: 50 RPM
Max: 60000 RPM
Default value: Configuration dependent
1-26 Motor Cont. Rated Torque
Default value: Configuration dependent
Parameter type: Range
2-setup: All setups
Conversion index: -1
Data type: u_int16
Change during operation: False
AU363928304090en-000101 / 130R0982 | 47Danfoss A/S © 2021.07
Parameters
VLT® Flow Drive FC 111
Programming Guide