• Planning a communication network off-line. MCT 10 contains a complete adjustable fre-
quency drive database.
• Commissioning adjustable frequency drives on-line.
• Saving settings for all adjustable frequency drives.
• Replacing an adjustable frequency drive in a network.
• Simple and accurate documentation of adjustable frequency drive settings after com-
missioning.
• Expanding an existing network.
• Adjustable frequency drives developed in the future will be supported.
MCT 10 Set-up software support Profibus DP-V1 via a Master class 2 connection. This makes it
possible to access on-line read/write parameters in an adjustable frequency drive via the Profibus
network. This will eliminate the need for an extra communication network.
Save Adjustable Frequency Drive Settings:
1. Connect a PC to the unit via the USB COM port. (Note: Use a PC that is isolated from the
AC line power, in conjunction with the USB port. Failure to do so may result in equipment
damage.)
2. Open MCT 10 Set-up software
3. Choose “Read from drive”.
4. Choose “Save as”.
All parameters are now stored on the PC.
Load Adjustable Frequency Drive Settings:
1. Connect a PC to the adjustable frequency drive via the USB com port
2. Open MCT 10 Set-up software
3. Choose “Open”– stored files will be shown.
4. Open the appropriate file.
5. Choose “Write to drive.”
All parameter settings are now transferred to the adjustable frequency drive.
A separate manual for the MCT 10 Set-up software is available:
MG.10.Rx.yy
.
VLT
®
HVAC Drive Instruction Manual
5. How to operate the adjustable frequency
drive
MG.11.A4.22 - VLT
®
is a registered Danfoss trademark
59
5
To Next Page
Loading...
