The MCT 10 Set-up Software Modules
The following modules are included in the software package:
MCT 10 Set-up Software
Setting parameters
Copy to and from adjustable frequency drives
Documentation and print-out of parameter settings incl. diagrams
Ext. User Interface
Preventive Maintenance Schedule
Clock settings
Timed Action Programming
Smart Logic Controller Set-up
Ordering number:
Please order the CD containing the MCT 10 Set-up software using code number 130B1000.
MCT 10 can also be downloaded from the Danfoss website:
www.danfoss.com - Business Area:
Motion Controls
.
5.1.7. Tips and tricks
* For the majority of HVAC applications, the Quick Menu, Quick Set-up and Func-
tion Set-up provide the simplest and quickest access to all the most commonly
required parameters.
* Whenever possible, perform an AMA to ensure the best shaft performance
* Display contrast can be adjusted by pressing [Status] and [ ] for a darker display▲
or by pressing [Status] and [ ] for a brighter display.▼
* Under [Quick Menu] and [Changes Made], all the parameters that have been
changed from the factory settings are displayed.
* Press and hold the [Main Menu] key for 3 seconds to access to any parameter.
* For service purposes, it is recommended to copy all parameters to the LCP; see
par 0-50 for further information.
Table 5.1: Tips and tricks
5.1.8. Quick Transfer of Parameter Settings when using GLCP
Once the set-up of an adjustable frequency drive is complete, it is recommended to store (backup)
the parameter settings in the GLCP or on a PC via MCT 10 Set-up software tool.
NOTE
Stop the motor before performing any of these operations.
5. How to operate the adjustable frequency
drive
VLT
®
HVAC Drive Instruction Manual
60
MG.11.A4.22 - VLT
®
is a registered Danfoss trademark
5
To Next Page
Loading...
