Data Aire DAP III User Manual

40
Once selections have been made,
MENU  - To view next sub-menu
Display will read: 4-21 REMOTE ALARM 2 SELECTION
SELECT  or  - To view current setting
Display will read: 4-21 REMOTE ALARM 2 SELECTION
aaaaaaaaa
Remote alarms may be grouped. To add or remove alarms press the SILENCE button. The added alarm will
be designated by an asterisk (*). Only those alarms with the asterisk (*) will be included in REMOTE ALARM 2.
NOTE: Remote alarm group 2 requires an optional Relay Module. If unit does not have a
Relay Module, the following message will be displayed:
4-21 – REMOTE ALARM 2 SELECTION
RELAY MODULE REQUIRED
Available alarms for group 2:
CHECK HUMIDIFIER CYLINDER LOCAL ALARM 3
CHILLED WATER SENSOR PROBLEM ALARM LOCAL ALARM 4
COMPRESSOR SHORT-CYCLE LOW DISCHARGE AIR TEMPERATURE ALARM
CUSTOM MESSAGE ALARM, OPT INPUT 1 LOW HUMIDITY ALARM
CUSTOM MESSAGE ALARM, OPT INPUT 2 LOW PRESSURE COMPRESSOR 1 ALARM
CUSTOM MESSAGE ALARM, OPT INPUT 3 LOW PRESSURE COMPRESSOR 2 ALARM
CUSTOM MESSAGE ALARM, OPT INPUT 4 LOW TEMPERATURE ALARM
DIRTY FILTER ALARM LOW VOLTAGE ALARM
DISCHARGE AIR SENSOR PROBLEM ALARM MAINTENANCE REQUIRED ALARM
FAN MOTOR OVERLOAD ALARM MANUAL OVERRIDE ALARM
FIRE STAT ALARM NO AIR FLOW ALARM
HIGH CONDENSATE WATER LEVEL NO WATER FLOW ALARM
HIGH HUMIDITY ALARM POWER PROBLEM, RESTART ALARM
HIGH PRESSURE/INTERNAL OVERLOAD: COMP 1 REHEAT & HUMIDIFICATION INHIBITED
HIGH PRESSURE/INTERNAL OVERLOAD: COMP 2 REHEAT INHIBITED
HIGH TEMPERATURE ALARM SMOKE DETECTOR ALARM
HUMIDIFICATION INHIBITED STANDBY PUMP ON ALARM
HUMIDIFIER PROBLEM ALARM TEMPERATURE SENSOR PROBLEM ALARM
HUMIDITY SENSOR PROBLEM ALARM UNIT IN STANDBY, ALL FUNCTIONS ARE OFF
LOCAL ALARM 1 UPS/ALTERNATE POWER ON ALARM
LOCAL ALARM 2 WATER DETECTION PROBE ALARM
Once selections have been made,
MENU  - To view next sub-menu
Display will read: 4-22 REMOTE ALARM 3 SELECTION
SELECT  or  - To view current setting
Display will read: 4-22 REMOTE ALARM 3 SELECTION
aaaaaaaaa
Remote alarms may be grouped. To add or remove alarms press the SILENCE button. The added alarm will
be designated by an asterisk (*). Only those alarms with the asterisk (*) will be included in REMOTE ALARM 3.

Data Aire DAP III Specifications

General

Brand	Data Aire
Model	DAP III
Category	Security System
Language	English