13
MENU GROUPS
Group 1 – Status and History Group 6 – Network
Group 2 – Setpoints Group 7 – Calibration
Group 3 – Operation Group 8 – Set-back**
Group 4 – Alarms Group 9 – Diagnostics
Group 5 – Confi guration Group 10 – Analog*
Gruop 11 – Zone Conrol
SUB-MENUS
Group 1 – Status and History
1-1 Temperature and humidity setpoints
1-2 Last 24 hours temperature and humidity
1-3 Percent capacity and average last hour
1-4 Equipment runtimes
1-5 Alarm history-clear alarm history
MENU GROUPS 2 THROUGH 11 REQUIRE A PASSWORD ENTRY
Group 2 – Setpoints
2-1 Change temperature setpoints
2-2 Change temperature deadband
2-3 Change humidity setpoint
2-4 Change humidity deadband
2-5 Change cooling stage-to-stage DB (deadband)
2-6 Change E-Saver CW (chilled water) temperature SP (setpoint)
2-7 Change E-Saver CW temperature DB
Group 3 – Operation
3-1 Set time and date
3-2 Mode and stage response time
3-3 Compressor lead/lag sequence
3-4 System start delay
3-5 Reset equipment run time
3-6 Automatic self-test acknowledge
3-7 Compressor supplements to E-Saver
3-8 Energy Saver lock-out time
3-9 Dehumidifi cation mode
3-10 Power problem or restart mode
3-11 Scheduled normal maintenance
3-12 Temperature scale
3-13 Fan mode*
3-14 Override request
3-15 Humidity anticipation
3-16 Humidifi cation desaturation cycle
3-17 Energy Saver to DX change over deadband
3-18 Constant fan speed for DX cooling
3-19 Constant fan speed for CW cooling
3-20 Fan speed control for DX cooling
3-21 Fan speed control for CW cooling
3-22 Maximum fan speed
3-23 Minimum fan speed
3-24 Differential pressure setpoint
3-25 Differential pressure deadband
3-26 Fan speed response rate
* Only displays when analog module is connected.
** Only displays when DAP III is in RFM (reduced function mode) ceiling systems.
To Next Page
Loading...
Need help?
General
