EasyManua.ls Logo

Data Aire DAP III - Page 14

Data Aire DAP III
94 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
SUB-MENUS- continued
Group 4 – Alarms
4-1 Audio alarm mode
4-2 Change high temperature alarm limit
4-3 Change low temperature alarm limit
4-4 Change hi humidity alarm limit
4-5 Change lo humidity alarm limit
4-6 Firestat temperature alarm limit
4-7 Low discharge temp alarm limit
4-8 Compressor short-cycle alarm
4-9 Water under fl oor alarm action
4-10 No water fl ow alarm action
4-11 Person to contact on alarm
4-12 Message for optional alarm input 1
4-13 Delay for opt. alarm input 1
4-14 Message for opt. alarm input 2
4-15 Delay for opt. alarm input 2
4-16 Message for opt. alarm input 3
4-17 Delay for opt. alarm input 3
4-18 Message for opt. alarm input 4
4-19 Delay for opt. alarm input 4
4-20 Remote alarm number 1 selection
4-21 Remote alarm number 2 selection
4-22 Remote alarm number 3 selection
4-23 Remote alarm number 4 selection
4-24 No airfl ow alarm time delay
4-25 No water fl ow alarm time delay (locked)
MENU GROUP 5 IS LOCKED – NO CHANGES CAN BE MADE UNTIL
MENU IS UNLOCKED
Group 5 – Confi guration
5-1 Sensor location
5-2 Defi ne password
5-3 Reduced Function Mode (RFM) active
5-4 Compressor(s)
5-5 Reheat stage
5-6 Humidifi er
5-7 Water valve mode
5-8 Water valve voltage control range
5-9 Reverse acting water valve
5-10 Humidifi er autofl ush timer Only displays when infared humidifi er installed
Group 6 – Network
6-1 Unit and network ID
6-2 Network protocol
6-3 IP address
6-4 Netmask address
6-5 Router address
6-6 UDP port
6-7 Ethernet TCP port
6-8 Baudrate (Only appear when ModBusRTU, Modbus ASCII, BACnet MS/TP and
Johnson Control N2 protocol is selected. Requires RS-485 communications card.)
6-9 Network ID
6-10 Device ID (this menu only shows when BACnet MS/TP or BACnet Master is selected)
6-11 Max Master (This menu only shows when BACnet MS/TP is selected.)
Menus 6-12 through 6-15 only appear when SNMPv1/v2 is selected.
Shaded menus only displayed when
Ethernet card is installed and confi gured
for Bacnet IP, MODBUS TCP or SNMP

Other manuals for Data Aire DAP III

Related product manuals