61
MENU - To view next sub-menu
Display will read: 9-10 TEST WATCHDOG RESET CIRCUIT
SELECT - To view current setting
Display will read: 9-10 TEST WATCHDOG RESET CIRCUIT
PRESS SELECT TO FORCE WATCHDOG RESET
NOTE: Running this test will cause the unit to shut down and restart.
SELECT - Watchdog will reset in two seconds. Panel will return to CURRENT OPERATING
FUNCTIONS & STATUS DISPLAY after running through its self-test procedure.
EXIT - Press EXIT button to return to GROUP 9 MENU
EXIT - Press EXIT again to return to Current Operating Functions & Status Display
OR
MENU - To view group 10.
Display will read: GROUP 10 - ANALOG
NOTE: The ANALOG menu, GROUP 10, will only display if an analog module is installed in
the DAP III. If there is no analog module in the DAP III menu 10 will not display. See Analog Mode
micro-switch setting for details on setting the analog signal ranges in sub-menu 10-3.
SELECT - To view sub menu 10-1
Display will read: 10-1 SELECT SENSOR 1 NAME
SELECT - To view 10-1 SELECT SENSOR 1 NAME
NOT INSTALLED
If there are no optional sensors factory installed in the unit, “NOT INSTALLED” will display.
However, if options have been factory installed that sensor will display. The following are sensor
options that are available:
INPUT VOLTAGE A-B OUTPUT CURRENT C CONDENSER WATER FLOW
INPUT VOLTAGE B-C NEUTRAL CURRENT CHILLED WATER FLOW
INPUT VOLTAGE A-C GROUND CURRENT ZONE AIR TEMPERATURE
OUTPUT VOLTAGE A-B FREQUENCY OUTSIDE AIR TEMPERATURE
OUTPUT VOLTAGE B-C POWER OUTSIDE AIR HUMIDITY
OUTPUT VOLTAGE A-C CONDENSER H2O SUPPLY TMP DISCHARGE PRESSURE
INPUT CURRENT A CONDENSER H20 RETURN TMP SUCTION PRESSURE
INPUT CURRENT B CHILLED WATER SUPPLY TMP DIFFERENTIAL PRESSURE
INPUT CURRENT C CHILLED WATER RETURN TMP PRESSURE
OUTPUT CURRENT A SUPPLY AIR TEMPERATURE FLOW
OUTPUT CURRENT B RETURN AIR TEMPERATURE
Group 10
To Next Page
Loading...
Need help?
General
