42
COMPRESSOR SHORT-CYCLE LOW DISCHARGE AIR TEMPERATURE ALARM
CUSTOM MESSAGE ALARM, OPT INPUT 1 LOW HUMIDITY ALARM
CUSTOM MESSAGE ALARM, OPT INPUT 2 LOW PRESSURE COMPRESSOR 1 ALARM
CUSTOM MESSAGE ALARM, OPT INPUT 3 LOW PRESSURE COMPRESSOR 2 ALARM
CUSTOM MESSAGE ALARM, OPT INPUT 4 LOW TEMPERATURE ALARM
DIRTY FILTER ALARM LOW VOLTAGE ALARM
DISCHARGE AIR SENSOR PROBLEM ALARM MAINTENANCE REQUIRED ALARM
FAN MOTOR OVERLOAD ALARM MANUAL OVERRIDE ALARM
FIRE STAT ALARM NO AIR FLOW ALARM
HIGH CONDENSATE WATER LEVEL NO WATER FLOW ALARM
HIGH HUMIDITY ALARM POWER PROBLEM, RESTART ALARM
HIGH PRESSURE/INTERNAL OVERLOAD: COMP 1 REHEAT & HUMIDIFICATION INHIBITED
HIGH PRESSURE/INTERNAL OVERLOAD: COMP 2 REHEAT INHIBITED
HIGH TEMPERATURE ALARM SMOKE DETECTOR ALARM
HUMIDIFICATION INHIBITED STANDBY PUMP ON ALARM
HUMIDIFIER PROBLEM ALARM TEMPERATURE SENSOR PROBLEM ALARM
HUMIDITY SENSOR PROBLEM ALARM UNIT IN STANDBY, ALL FUNCTIONS ARE OFF
LOCAL ALARM 1 UPS/ALTERNATE POWER ON ALARM
LOCAL ALARM 2 WATER DETECTION PROBE ALARM
MENU - To view next sub-menu
Display will read: 4-24 NO AIR FLOW ALARM TIME DELAY (Locked menu)
SELECT or - To view current setting
Display will read: 4-24 NO AIR FLOW ALARM TIME DELAY
ALARM DELAY: nnn SECONDS
SELECT or - To change alarm delay from 60 to 180 seconds in 1 second increments.
Factory setting is: 5 SECONDS
MENU - To view next sub-menu
Display will read: 4-25 NO WATER FLOW ALARM TIME DELAY (Locked menu)
SELECT or - To view current setting
Display will read: 4-25 NO WATER FLOW ALARM TIME DELAY
ALARM DELAY: nnn SECONDS
SELECT or - To change alarm delay from 60 to 180 seconds in 1 second increments.
Factory setting is: 60 SECONDS
EXIT - Press EXIT to return to Group 4 - ALARMS
EXIT - Press EXIT again to return to Current Operating Functions & Status Display
OR
To Next Page
Loading...
Need help?
General
