DataCard CE840 Installation And Administrator's Guide

CE870 Instant Issuance System Installation and Administrator’s Guide 71
 EthAddressMethod—The method used to obtain the IPv4 network IP address. Select DHCP
or STATIC from the Current Value drop-down list.
 When the value is DHCP, the EthGatewayAddress, EthIpAddress, and EthSubnetMask
values are controlled by the DNS server and the settings are filled in automatically.
 When the value is STATIC, the EthGatewayAddress, EthIPAddress, and EthSubnetMask
values must be set manually.
 EthGatewayAddress—Enter the gateway address for the Ethernet network.
 EthIpAddress—Enter the static IP address for the printer.
 EthSubnetMask—Enter the subnet mask for the Ethernet network.
 EthDnsAddress1, EthDnsAddress2, EthDnsSearchSuffix—These settings are not used at this
time.
 IPMode—Specify the IP mode used by the printer. The printer can support both IPv4 and
IPv6 addressing. You can select from the following
 IPv4—The printer uses IPv4 addressing only.
 DualStack—The printer can use both IPv4 and IPv6 addressing.
The remaining IPv6 settings become applicable when IPMode is set to DualStack.
 IPv6DefaultGateway—Set a default gateway address. This setting is disabled when set to the
default of “::”.
 IPv6DHCPv6Select—Select whether or not the printer obtains an address and stateful
configuration from a DHCPv6 server. Disable this setting if a DHCPv6 server is not present.
 IPv6DNSPrimaryAddress, IPv6DNSSecondaryAddress—These settings are not used at this
time.
12) IPv6DNSSecondaryAddress :: ::
13) IPv6ManualAddress :: ::
14) IPv6ManualPrefixLength 64 64 [0 – 128]
15) IPv6ManualSelect Disabled Enabled
16) IPv6StatelessAddrSelect Enabled Disabled
Description Default Value
Current Value
(unit)
Allowed
Range

DataCard CE840 Specifications

General

Brand	DataCard
Model	CE840
Category	Printer
Language	English