Datacard CR500 User Reference Guide Load Supplies
13
12
5b
5c
5d
5a
4. Remove both used lm spools from the cartridge (if present).
5. Load the new roll of retransfer lm on the cartridge:
a. Put the full roll of lm on the green supply spindle.
b. Align the retransfer lm along the three lm guides, as shown on the
cartridge diagram.
c. Put the empty take-up spool on the black take-up spindle and wind two
frames of lm onto the take-up spool.
d. Turn the take-up knob on the underside of the cartridge to remove any
slack. Gently pull out the take-up knob so it turns smoothly.
If slack cannot be removed, check that the supply and take-up spools
are rmly seated on the spindles. To insert the cartridge into the printer,
the lm must be ght along the lm guides. Use the supply and take-up
knobs to maintain the proper tension.
6. Insert the loaded cartridge in the printer unl it clicks into posion.
7. Close the print unit door.
8. On the print unit front panel, press Reset and then Return to inialize the lm.
9. Close the security enclosure door to lock printer.
To Next Page
Loading...
Need help?
General
