DataCard SD460

90 Card Design Tasks
4. Evaluate the appearance of the cards.
5. Repeat these steps until the cards meet your requirements.
6. Click Apply to save the new values.
Contrast
The Contrast setting changes the degree of
difference between the light and dark
values of an image.
1. Click the Up arrow to increase
contrast, or the Down arrow to
decrease contrast.
The Adjusted image shows the effect
of the new setting.
2. Click Apply after each change to save
it.
3. To verify changes, do one of the
following:
 Print one or more cards from your
card production software.
 Print a sample card from the Printer Properties > Printer Status page.
4. Evaluate the appearance of the cards.
5. Repeat these steps until the cards meet your requirements.
6. Click Apply to save the new values.