Datacom DM984-100B - TCONT-VP-BIND-Profile

DM984 product family CHAPTER 11. IPSAN CONFIGURATION
The next step is to assign a priority. For this purpose there exists the com-
mand:
upstream-flow-priority <prio>
Description of the used parameters:
Name Format Description
<prio> Number (0-7) Upstream Flow Priority
Example for VP-SVC-Profile creation:
DM4650(config)#profile gpon vp-svc 123
DM4650(config-prof-gpon-vp-svc-123)#upstream-flow-priority 1
DM4650(config-prof-gpon-vp-svc-123)#exit
DM4650(config)#
11.6.5 TCONT-VP-BIND-Profile
This profile makes it possible to create different T-CONTs and to assign it a
bandwidth profile. It is also possible to create the mapping of GEM ports to
their specific T-CONT.
The following steps are done in the configuration menu. For the creation of
a TCONT-VP-BIND-Profile the following command is given
profile gpon tcont-vp-bind <name>
Description of the used parameters:
Name Format Description
<name> Alphanumeric Name of the TCONT-VP-BIND-Profile
Note: When the chosen name is already taken it will change the existing entry.
Then it is necessary to create the T-CONTs and assign it a bandwidth. This
is done with the command
tcont <tcont-id> sla <sla-profile>
Description of the used parameters:
Name Format Description
<tcont-id> Number (1-6) ID of the T-CONT
<sla-profile> Alphanumeric Name of the previously created SLA-Profile
Note: When the chosen id is already taken it will change the existing entry.
DATACOM
204.4288.00