6-74 Magellan
®
8100/8100Ω and 8200/8200Ω Scanner
RS-232 Parity
Specifies parity required for sending and receiving data.
Options for this setting are:
• RS-232 PARITY = NONE
• RS-232 PARITY = EVEN
• RS-232 PARITY = ODD
To set this feature:
1. Scan the SWITCH bar code.
2. Scan the bar code below or on the following pages representing
the desired Parity setting. You’ll need to cover any unused bar
codes, as well as facing pages to ensure that the scanner reads only
the bar code you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
RS-232 PARITY = NONE
To Next Page
Loading...
