Datalogic MAGELLAN 8200

Product Reference Guide E-1
Appendix E
Factory Defaults
The following table provides a listing of the most common factory settings
for the interfaces shown.
Table 5-1. Factory Default Settings
Aux RS-232
Wincor-
Nixdorf
Single
Cable
IBM 17 IBM USB
Double Read Timeout
60
(600ms)
60
(600ms)
60
(600ms)
60
(600ms)
60
(600ms)
60
(600ms)
Laser Timeout 20 (5 min.) 20 (5 min.) 20 (5 min.) 20 (5 min.) 20 (5 min.) 20 (5 min.)
Motor Timeout
40
(10 min.)
40
(10 min.)
40
(10 min.)
40
(10 min.)
40
(10 min.)
40
(10 min.)
Green LED Idle State 2 (on dim) 2 (on dim) 2 (on dim) 2 (on dim) 2 (on dim) 2 (on dim)
Scanner Button Options
1
(vol/tone/
reset)
1
(vol/tone/
reset)
1
(vol/tone/
reset)
1
(vol/tone/
reset)
1
(vol/tone/
reset)
1
(vol/tone/
reset)
Power-up Beep Control 1 beep 1 beep 1 beep 1 beep 1 beep 1 beep
Good Read Beep Con-
trol
1 (enable) 1 (enable) 1 (enable) 1 (enable) 1 (enable) 1 (enable)
Good Read Beep Fre-
quency
1
(medium)
1
(medium)
1
(medium)
1
(medium)
1
(medium)
1
(medium)
Good Read Beep
Length
8 (80ms) 8 (80ms) 8 (80ms) 8 (80ms) 8 (80ms) 8 (80ms)
Good Read Beep Vol-
ume
3 (med-
high)
3 (med-
high)
3 (med-
high)
3 (med-
high)
3 (med-
high)
3 (med-
high)
Good Read When to
Indicate
0 (after
decode)
0 (after
decode)
0 (after
decode)
0 (after
decode)
0 (after
decode)
0 (after
decode)
Scale Enable 0 (disable) 1 (enable) 0 (disable) 1 (enable) 1 (enable) 1 (enable)
Scale Country Mode 0 (US) 0 (US) 0 (US) 0 (US) 0 (US) 0 (US)